3.13 NITROGLYCERINE
Nitroglycerine is one of the most sensitive explosives, if it is not
the most sensitive. Although it is possible to make it safely, it is difficult.
Many a young anarchist has been killed or seriously injured while trying to
make the stuff. When Nobel's factories make it, many people were killed by the
all-to-frequent factory explosions. Usually, as soon as it is made, it is
converted into a safer substance, such as dynamite. An idiot who attempts
to make nitroglycerine would use the following procedure:
MATERIAL EQUIPMENT
distilled water eye-dropper
table salt 100 ml beaker
sodium bicarbonate 200-300 ml beakers (2)
concentrated nitric ice bath container
acid (13 ml) ( a plastic bucket serves well )
concentrated sulfuric centigrade thermometer
acid (39 ml)
blue litmus paper
glycerine
1) Place 150 ml of distilled water into one of the 200-300 ml beakers.
2) In the other 200-300 ml beaker, place 150 ml of distilled water and about
a spoonful of sodium bicarbonate, and stir them until the sodium bicarbonate
dissolves. Do not put so much sodium bicarbonate in the water so that some
remains undissolved.
3) Create an ice bath by half filling the ice bath container with ice, and
adding table salt. This will cause the ice to melt, lowering the overall
temperature.
4) Place the 100 ml beaker into the ice bath, and pour the 13 ml of concentrated
nitric acid into the 100 ml beaker. Be sure that the beaker will not spill
into the ice bath, and that the ice bath will not overflow into the beaker
when more materials are added to it. Be sure to have a large enough ice bath
container to add more ice. Bring the temperature of the acid down to about 20
degrees centigrade or less.
5) When the nitric acid is as cold as stated above, slowly and carefully add the
39 ml of concentrated sulfuric acid to the nitric acid. Mix the two acids
together, and cool the mixed acids to 10 degrees centigrade. It is a good
idea to start another ice bath to do this.
6) With the eyedropper, slowly put the glycerine into the mixed acids, one drop
at a time. Hold the thermometer along the top of the mixture where the mixed
acids and glycerine meet. DO NOT ALLOW THE TEMPERATURE TO GET ABOVE 30
DEGREES CENTIGRADE; IF THE TEMPERATURE RISES ABOVE THIS TEMPERATURE, RUN
LIKE HELL!!! The glycerine will start to nitrate immediately, and the
temperature will immediately begin to rise. Add glycerine until there is a
thin layer of glycerine on top of the mixed acids. It is always safest to
make any explosive in small quantities.
7) Stir the mixed acids and glycerine for the first ten minutes of nitration,
adding ice and salt to the ice bath to keep the temperature of the solution
in the 100 ml beaker well below 30 degrees centigrade. Usually, the
nitroglycerine will form on the top of the mixed acid solution, and the
concentrated sulfuric acid will absorb the water produced by the reaction.
8) When the reaction is over, and when the nitroglycerine is well below 30
degrees centigrade, slowly and carefully pour the solution of nitroglycerine
and mixed acid into the distilled water in the beaker in step 1. The
nitroglycerine should settle to the bottom of the beaker, and the water-acid
solution on top can be poured off and disposed of. Drain as much of the
acid-water solution as possible without disturbing the nitroglycerine.
9) Carefully remove the nitroglycerine with a clean eye-dropper, and place it
into the beaker in step 2. The sodium bicarbonate solution will eliminate
much of the acid, which will make the nitroglycerine more stable, and less
likely to explode for no reason, which it can do. Test the nitroglycerine
with the litmus paper until the litmus stays blue. Repeat this step if
necessary, and use new sodium bicarbonate solutions as in step 2.
10) When the nitroglycerine is as acid-free as possible, store it in a clean
container in a safe place. The best place to store nitroglycerine is
far away from anything living, or from anything of any value.
Nitroglycerine can explode for no apparent reason, even if it is stored
in a secure cool place.
3.36 DYNAMITE
The name dynamite comes from the Greek word "dynamis", meaning power.
Dynamite was invented by Nobel shortly after he made nitroglycerine. It was
made because nitroglycerine was so dangerously sensitive to shock. A misguided
individual with some sanity would, after making nitroglycerine (an insane act)
would immediately convert it to dynamite. This can be done by adding various
materials to the nitroglycerine, such as sawdust. The sawdust holds a large
weight of nitroglycerine per volume. Other materials, such as ammonium nitrate
could be added, and they would tend to desensitize the explosive, and increase
the power. But even these nitroglycerine compounds are not really safe.